How to Install a Pond Filter & Pump

Save

Introducing a pond is a beautiful way to make a focal point in any garden or yard. These ponds are relatively inexpensive to construct, and add a touch of elegance to your landscaping. Ponds can also increase the value of your home.

Things You'll Need

  • Reinforced garden hose Shovel Garden wire Outdoor electrical outlet RCCD trip switch Pond pump Pond filter Hose clips Scissors
  • Construct a conduit to place around the edging of the pond--a reinforced hose works well. Bury the hose underground with a shovel, so it runs from the pond to the electrical connection. Thread garden wire through the hose.

  • Cut a 12 mm, or 1/2 inch, section from the pump hose tail. Screw the pump hose tail into the pump. Connect the hose with a hose-clip.

  • Situate the pump in the bottom of the pond, opposite the pond from the filter. Attach and tape the pump's cable to the conduit's garden wire and push it through the conduit.

  • Set up the pump filter, according to the manufacturer's instructions. Connect the pump tubing to the filter's inlet with a hose clip; the clip should be located on the left side of the hose tail.

  • Attach a suitable plug to the pump cable. Connect the power to a separate breaker, through an RCCD trip switch.

Related Searches

References

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!