How to Change your Moped/Scooters Engine Oil in 5 minutes
by Editorial Team
This will help you change your own Scooter/Mopeds oil for only $3 or less. It will take you less than 5 minutes to do this.
Step 2
Next we need to locate the oil drain plug. If you take you fingers and run them down the side of the engine to the botttom, right below where you removed the dipstick from, you should feel a bolt. On most scooters it is square. Place the small cool whip container(or small pan) under that square plug.
Step 3
Take your adjustable wrench and tighten it to the bolt and then start to unscrew it. Remember lefty loosy, righty tighty. Turn to the left until it comes off. The oil will drain into the container or pan you placed under it.
Step 4
There is normally a small spring attached to the screw. Clean that of debre and then screw the plug back into the moped turning to the right. Then fill the engine with oil. Check the dipstick to make sure you fill it to the proper level, and check underneath to make sure you don't have any leaks from the oil plug.
Step 5
After it is filled to the proper level, start your engine and let it run for 30 seconds. Then stop the engine and check your oil level again adding if necessary.
Tips
- Having a rag handy is always a good idea
Things You'll Need
- 1 quart of Suggested motor oil
- adjustable wrench or wrench set
- Cool Whip container or low pan
Warnings
- Make sure to drop the used oil off at a service station for propper recycling.
Writer Bio
This article was written by the CareerTrend team, copy edited and fact checked through a multi-point auditing system, in efforts to ensure our readers only receive the best information. To submit your questions or ideas, or to simply learn more about CareerTrend, contact us [here](http://careertrend.com/about-us).
