How to Add a Second Keyless Entry Pad to a Garage Door Opener

A keyless entry system for your garage door opener can be a time-saving device and can be very helpful to children and friends. These devices are relatively inexpensive and can be installed in just a few hours.

Difficulty: Moderate

Instructions

Things You'll Need:

• Screwdriver
• Tape measure

1. Select a keyless entry system that is compatible with your opener. Many openers are not equipped to work with a wireless unit, so this article will be looking at units that are hard-wired. In this case, you have several more options because the remote will be hard-wired to your opener.

2. Determine where you want the keyless remote mounted. If you intend these to be accessible to children, you need to take that into consideration when selecting the mounting position and height.

3. Depending on your intended application, you will want to choose a location semi-protected from the weather. Carefully measure and mark the desired location and secure the unit into place. Make certain all necessary wiring connections are made prior to mounting the unit.

4. Run the wires to the garage door opener. The actual wiring will vary for each model as well as the model of keyless system you have purchased. Attach the wires as directed in the wiring diagram supplied with the keypad.

5. Set the PIN for each keypad. You may use different PINs if you choose, but it is not advisable. After the PIN is programed, the keypads may be used to activate the opener. Test the system, but do not operate the opener repeatedly without allowing it time to cool, or damage may occur.

Tips & Warnings

• If mounting the second keyless system for children, you could mount it directly below the unit mounted at the proper height for adults. This would allow you to run your wires along the same route and make for easier installation.
• Do not use a code such as 1-2-3-4 or your birth date or anniversary. Would-be criminals can obtain these numbers and know many people use them as their codes.