How to Strip a Jack Russell Terrier's Coat

Member

By Janet Ford
User-Submitted Article

Article Rating: (3 Ratings)

Parson Russell Terrier aka 'Jack Russell Terrier'

The name of Jack Russell Terrier was recently officially changed to Parson Russell Terrier by the American Kennel Club.
There are three coat varieties in a Parson Russell Terrier; smooth, semi-rough and rough coated. To be shown, the semi-rough and rough coated varieties need to have their hair shortened. To do this with a wire coated dog such as the Parson Russell is to 'strip' the coat. This is basically pulling the longer coarser hairs out. Done properly, this causes the dog no pain.

Difficulty: Moderately Easy

Instructions

Things You'll Need:

Striping Knife (optional)
Patience

Step 1

Study some photos of parson/jack russell terriers who are being shown. Semi-rough and rough coated terriers will have some facial fringe left on them. This is where you need to really study.
Step 2

Choose your striping knife carefully. There are different varieties depending on the coarseness of your dog's coat. If you are unsure, ask your dog's breeder or someone experienced who has seen your dog. I prefer having two striping knives on hand. One for more rough coats and one for finer coats. Even different parts of a terriers body may require a different type striping knife.
Step 3

Devote an entire day or maybe a few days where you can work patiently on stripping your parson/jack russell's coat. Some terriers are easier to strip than others. I have one that takes me three days and another I can strip down in a matter of two hours.
Step 4

Prepare your parson/jack russell terrier by having them exercise and run off some energy. Don't begin this job until the dog is relaxed and ready for a rest.
Step 5

Begin at the back bone. This seems to be the easiest point to begin for me with my dogs. Using a striping knife, this job is made much easier but you can use your hands or even a dull serrated knife.
Step 6

To use a striping knife, hold the striping end of the grooming tool with your index finger behind, comb up a small portion of long, coarse dog hair and use your thumb to hold it in place as you gently pull out the hair.
Step 7

To use your bare hands, use one hand to hold the dog's skin firmly down while you gently pull a very small section of hair out with the other hand. This hair should come free fairly easy on the torso area. It will be a bit tougher to remove on the legs and feet.
Step 8

Using your photo references, trim up the face area. Be extra careful to only pull a few hairs at a time. This is where the patience comes in. The fringe is important to the overall look. Many judges seem to prefer the semi-rough or rough coated parson/jack russell terriers because of this fringe.

Comments

henrylover said

Flag This Comment

on 7/7/2009 We have a rough coat JRT, and a stripping comb works very well. Henry has the typical high energy of a JRT, but the short raking motion seems to relax him and he cooperates for however long I groom him. The comb removes all the loose hair that would otherwise cover our furniture, car seats, and clothing. I use a small sharp scissors for around his eyes, in his ears, and on his feet and rear end. Then he gets a bath, and he's good for three or four months. It's at about that point that we notice his white hair starting to cover everything again, reminding us that it's time to groom.!!