How to Modify Your Nerf Vulcan Chain

Today I am going to teach you how to make your Nerf Vulcan shoot even further with minimal work! Just read the next couple of steps to learn how.

Difficulty: Easy

Instructions

Things You'll Need:

• A Nerf Vulcan
• A Nerf Vulcan Chain (should be included when bought)
• A box knife or sharp scissors

1. Flip the belt onto it's back.

2. Look at the back, it should look like 3 circle-esque holes. This is the back of the air restrictor.

3. 
    

   Use your box knife and cut the top and bottom. The air restrictor will still be held. Be careful not to completely destroy the belt because the plastic is soft.

4. 
    

   Repeat Step 3 on the right most hole and the air restrictor should fall out. The air restrictors aren't all the same size, when I cut my air restrictors out, there were 3 or 4 of them that were smaller and fatter.

5. 
    

   Repeat Steps 3 and 4 until you are done with the entire belt. It should end up looking something like shown in the picture. Don't worry if there are small cuts on the sides of the bullet cases unless it is a major cut. Congratulations, you have finished modding your Nerf Vulcan belt!

Tips & Warnings

• I recommend using a box knife
• Possible Injuries: Minor cuts