Things You'll Need:
- Laserlyte kit
- Rifle targets
- Small slotted screwdriver
-
Step 1
Ensure that the firearm is unloaded. Remove magazine, open bolt and visibly confirm that the firearm's chamber is empty. Support the firearm in a sturdy rest, as if you were shooting at a gun range.
-
Step 2
Measure 25 yards from the firearm and hang the supplied product card target on a target frame. Locate the correct sized adapter for the caliber of your firearm. Using the correctly sized screw, install the adapter onto the end of the laser. Turn the screw until the adapter fits tightly inside the barrel. Slide the laser with the adapter into the muzzle end of the barrel.
-
Step 3
Remove the protective caps from the scope's windage and elevation turrets. Turn the laser on by twisting the "on/off" switch. Adjust the position of the rifle until the laser is impacting the product card target dead center in the bull's-eye.
-
Step 4
While being careful not to disturb the position of the rifle, look through the scope and see where the crosshairs line up in relation to the laser dot on the target. Using a small screwdriver or coin, adjust the scope's crosshairs till they are centered on the laser dot.
-
Step 5
Remove the Laserlyte bore sighter from the barrel. Place a target at 100 yards and shoot a three shot group. Make any small changes needed until the group is centered on the bull's-eye. The rifle is now sighted in.
