Hooking up a pressure tank is essential to a water well system to provide proper pressure and consistency to your water gpm. Hookup is simple and straightforward; installation can be done in about an hour. Following the proper steps will ensure a successful hookup of your pressure tank.
Things You'll Need
- Plumber's wrench
- Teflon pipe thread
Turn off the electricity to the well at the main breaker.
Install a T-fitting into your pipe that comes from the well to the house. Install the T-fitting after the check valve.
Run piping from the new end of the T-fitting to your pressure tank. Wrap Teflon pipe thread tape three to four times around the end, wrapping the threads fully.
Screw the end into the pressure tank with your plumber's wrench.
Turn the system back on and test for leaks.
How to Hook Up a Jet Pump to a Shallow Well for Home Use
In many areas, the water table is close enough to the surface that a shallow well can tap into the ground water....
How to Hook Up a Hot Water Tank
A hot water tank, otherwise known as a hot water heater, is a device that keeps a steady supply of hot water...
How to Run Well Pressure Tanks in a Series
Pressure tanks on wells allow the pressure to remain constant while saving needless wear and tear on the pump. If you are...
How to Install a Square D Water Pressure Switch
The pressure switch on your well is responsible for automatically sensing the need for more water in your pressure tank and supplying...
Camper Water Hookup Instructions
A camper, recreational vehicle (RV) or motor home allows you travel with many of the amenities of home. However, in order to...