How to Wire a Craftsman Garage Door Opener

Save

Wiring your garage-door opener is a fast and easy process. All garage-door openers are designed to plug in to an outlet; all you need is for the outlet to be close enough to the opener that the latter can be plugged in. Installing an outlet will take about 1 hour, depending on your experience level.

Things You'll Need

  • Electrical wire Conduit box Faceplate Wire cutter Hammer Nails
  • Turn off the electricity at the main breaker.

  • Go to the nearest outlet and unscrew the faceplate. With the faceplate off, you will see two screws: one on the top and one on the bottom of the outlet. Unscrew these, and pull the outlet out from the wall.

  • Run your electrical wire through the wall to the outlet you just unscrewed. Strip about 1 inch off the ends of the electrical wire, and screw onto the outlet screws. Make sure you are matching the wire color: white with white and black with black.

  • Screw the outlet back in. From where you started the wire in the wall, run it to where your new outlet will be.

  • With a hammer, nail your conduit box to the joist your garage door opener is on, securing it tightly. Put the wire through the conduit box.

  • Strip about 1 inch off the ends of the wire and screw onto your new outlet, using the screws on the outlet. Again, make sure to match the wire to the correct screw. The outlet will be labeled "white" and "black" for the wire colors. Screw the outlet to the conduit box and put on the new faceplate.

  • Plug in your garage opener and turn the electricity back on.

Tips & Warnings

  • Turn off the electricity before starting.

Related Searches

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!