How to Install Solar Pool Covers


Solar pool covers use plastic bubbles to filter sunlight down into the water and warm it. That can save you a great deal of money on heating costs, as well as allowing you to enjoy nice, warm pool water without having to wait for the heat pump. Some solar pool covers utilize formal cranking mechanisms that allow your to unfurl it and reel it back in at a moment's notice. They're not required, however, and you can install a solar pool cover of your own with just a little bit of planning.

Things You'll Need

  • Tape measure Scissors Marker
  • Measure the size of your pool with a tape measure to determine what size pool cover you need. The cover needs to fit over the surface of the pool precisely, and in most cases must be cut to specification after you buy it. At this stage, you simply want accurate measurements for comparison purposes. If you have an abnormally shaped pool, don't panic. Simply measure it at its widest point and at its longest point; that's sufficient to determine the right size for your pool cover.

  • Contact a pool supply store and see if you can purchase a solar pool cover that matches your specifications exactly. If you can't (and you often won't), then purchase one larger than what you require. You can then cut it to match your pool's size.

  • Lay the pool cover flat across your pool--bubble-side down--taking care to smooth out any wrinkles or folds. Mark the location of the pool sides along the cover with a magic marker.

  • Cut your pool cover to size with a pair of scissors, using the markings you have made as a guide. You want the cover to match your pool specifications exactly. A good rule of thumb is to make two series of cuts: the first one a "general" sizing, and the second a "trim" to make sure it all fits.

  • Lay the re-cut pool cover across your pool. It won't sink, and the seal it makes with the water will help it to work its best.

  • Stand on one end of the pool and pull a length of the cover measuring about 1 foot up onto the patio. Make a fold and pull another foot up, then fold it again and pull another foot up, and so on until the entire cover is up. This "accordion" folding takes up a minimum of space, and will allow you to quickly replace the cover across the pool when you're done swimming.

Tips & Warnings

  • Store your pool cover in the same location as your other supplies when you are done using the pool for the season. Keep it dry and out of undue heat or cold to prevent damage.
  • Never lay a solar pool cover across any grass or plant life. The accentuated sunlight will kill the greenery.

Related Searches

Promoted By Zergnet


You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!