How to Build a High Tensile Electric Fence

Building a high tensile electric fence is an essential skill to keep farm animals and livestock contained within a certain temporary perimeter without the cost and labor of installing a permanent fence.

Things You'll Need

• Pliers Roll of high tensile wire Fence stretcher Steel hot wire rods Screw-on plastic insulators Glass donut insulator Hammer 12-volt battery High voltage, low impedance, short pulse fence charger (AC plug-in type preferred, but battery operated and solar models are fine)

Instructions

1. Unroll wire around the perimeter. Tie the end of the 10-14 gauge high tensile wire to a corner post glass donut insulator. You must have solid wooden corner posts to construct an electric fence. Do one side at a time.

2. Stretch the fence. Once you have unrolled the wire on one side, cut the wire a bit longer than the distance of the side you have just unrolled the wire spool on. Use the fence stretcher to grab the end of the wire and hook the stretcher around the corner post and begin to ratchet the stretcher and tighten the wire. Once it becomes hard to ratchet the fence stretcher stop.

3. 

   With the glass donut insulator, put a spare piece of wire through the hole and tie it loosely to the corner post. Then with the tightened piece of wire in the fence stretcher, wrap it tightly around the donut and make sure it only touches the glass insulated part. Remove the fence stretcher.

4. Hot wire the rods. Now that you have the wire connected and tightened you need to get the wire off the ground. To do this you will screw plastic insulators onto the 3 to 4-foot steel rods and attach them to the wire and then proceed to hammer the rod into the ground about 6 inches and adjust the wire height in accordance to the animals you are containing. You can make a judgment on how far apart the rods should be depending on how low the wire is sagging. A good rule of thumb is usually 50 feet.

5. Install the voltage. At the corner of the enclosed area that is either closest to a power outlet or is the easiest to access, is where you will install the fence charger. There are AC plug-in, battery, and solar power operated types of fence chargers; each have their benefits and operate equally well with proper maintenance. Make sure to attach the fence chargers ground wire to an extra rod that you will pound into the ground.