×

How to Remove a Corbin Russwin Doorknob

Eva Talent

Corbin Russwin produces deadbolt locks and doorknobs. The two types of Corbin Russwin doorknobs available, its G10 series and the Anti-Harm Knob, are mounted with two Phillips screws on the door's inside panel. When these doorknobs loosen or suffer damage, they should be replaced immediately.

Broken doorknobs pose a loss of security.

Not replacing a problematic doorknob might result in the loss of a secure entrance.

  1. Open the door. Hold the outside doorknob in place with one hand.

  2. Place a Phillips screwdriver into the head of the top screw. Turn the screwdriver counterclockwise.

  3. Remove the screw from its hole. When the screw's threads no longer are holding the screw, the screw will hang from the hole or fall out.

  4. Place the screwdriver into the grooves on the bottom screw. Turn the screwdriver counterclockwise. Remove the screw when it no longer is threaded to the inside of the knob.

  5. Pull the inside part of the doorknob straight out while holding the outside portion of the doorknob in place. Do not jiggle the doorknob to remove it because this might cause damage to the interior locking mechanism. Use steady pressure to pull the doorknob out of the door.

  6. Remove the outside portion of the doorknob by pulling it straight out. Pulling the knob out at an angle also might damage the door and the knob's interior locking mechanism.

  7. Warning

    Hold the outside portion of the doorknob at all times to prevent it from falling. If you are unable to hold it while unscrewing the screws, ask a partner to hold it in place.

The Drip Cap

  • Corbin Russwin produces deadbolt locks and doorknobs.
  • Turn the screwdriver counterclockwise.
  • Place the screwdriver into the grooves on the bottom screw.
  • Pulling the knob out at an angle also might damage the door and the knob's interior locking mechanism.