Can a 2-Wire DSL Modem Be Reprogrammed?
Normally, a 2-wire DSL modem is used when you subscribe to AT&T or in many areas SWB DSL Internet service. The modem is a proprietary brand specifically designed for these carriers. Therefore, if a home user decides to set up a home network either using a multi-port router (also known as a hub) or a wireless router, the 2-wire modem has to be reconfigured.
Other People Are Reading
Things You'll Need
- DSL Internet connection
- 2-wire DSL modem
- Ethernet cables
- Network router
- Networking card
Instructions
-
-
1
Connect the modem directly to your computer, leaving out the router for now.
-
2
Log in to the modem to access its setup features. Open a browser and type in the following URL: "http://gateway.2wire.net/management." If this doesn't work, your model may still be accessed using one of these two IP addresses in the browser address bar: "http://192.168.0.1" or "http://192.168.0.2."
-
-
3
Click on the "Broadband Link" menu and then the "Configuration" option.
-
4
Disable the PVC search function. Also in the configuration menu, set the VPI value to 0 and the VCI to 35. These values can vary depending on your service provider, so note your original values before you change them.
-
5
Change the connection type to Direct IP. Click on "submit" to save the changes.
-
6
Click on the "Configure Services" menu. Disable the "Enable Routing" option. This will complete the task of reprogramming your 2-wire DSL modem by placing it in bridge mode. At this point you are ready to connect your router and set it up for direct access to your Internet service.
-
1
Tips & Warnings
Always make a note of any values that you change in case you need to reset them.
Always write down any user names and passwords created or used in connection with your ISP account.
Be sure you have your default password and initialization key before starting (usually found in original documentation).
Once you place your modem into bridge mode, you will be unable to access it using the browser login.
Modem can be reset from bridge mode manually using the reset button on the back of the modem. However, the default password and initialization key will be required after a reset to access the modem.
