You can add beauty and value to your landscape with bricks made from concrete. The versatility of concrete allows you to make simple forms for bricks. These wooden forms can be used time and time again. By following these steps you can setup your own small brick making process for a weekend project.
Things You'll Need
- 1 – 8 foot pine board, 1 inch by 4 inches
- Tape measure
- Safety glasses
- Circular saw
- 20 - 1¼ inch wood screws
- Drill motor
- Philips head driver bit for drills
- Ready mix concrete
Lay out the area you want to cover so can have a good idea of how many bricks you want to make. For this project we will be using an 8-foot pine board measuring 1 inch by 4 inches for the brick concrete forms. The form will to hold enough concrete to make four bricks for each form.
Measure 4 inches for the form width on the 1-by-4 board by marking a line with the pencil and squaring a line for a straight cut. Be sure to wear your safety glasses when cutting any type of material with a circular saw. Cut the board and repeat the measuring and cutting until you have five, 4-inch long boards. Next measure 38 inches and cut two boards at this length.
Attach the four inch boards inside the two 40 inch board with two of the 1 Â¼ inch screws using the drill motor and the Philips head driver bit. Begin at one end and attach the board, measure 8 inches, make a mark and screw on the next 4-inch board. This will give you one brick form, repeat the process until all five, 4-inch boards are in place. The form should have four openings that are 4 inches wide and 8 inches long and 3 Â¾ inches deep.
Mix the concrete according to the manufacture's directions and pour into the forms. You can use a small piece of leftover board to level the concrete across the top of the form. It may take a little trial and error to mix just the right amount of concrete to fill the form. It is better to mix too little than too much. Allow the concrete to set up over night.
Remove one of the 40-inch boards by unscrewing the ten screws along one side of the brick form. This will allow for easy removal of the hard bricks. Reattach the form board and you are ready to go again. Of course you can make many forms in this manner and pour multiple bricks at one time. The more forms you have the more bricks you can make.
Tips & Warnings
- Lay a sheet of plastic under the wooden forms before you lay in the concrete. The plastic will protect the surface under the forms and keep the concrete from adhering to the surface underneath.
About the Process of Making Mortar
People working in construction, such as bricklayers, use mortar to fill the gaps between bricks, blocks and rocks to keep them together....
How to Make a Cement Sidewalk Look like Stone or Brick
This is a few techniques I have used
How to Make Molds for Concrete Landscaping Bricks
With a mold for concrete landscaping bricks, you can easily make decorative paving stones at home. Creating beautiful landscaping stones from concrete...
How Does a Concrete Brick Making Machine Work?
Concrete brick and block making machines come in many sizes. They range from simple manual machines that make 100 blocks or bricks...
Concrete Block Vs. Brick
Both concrete block and brick masonry are strong, fire-resistant, insect-proof building materials. They have a lot of thermal mass, which helps them...