How to Lay A Path Of Stepping Stones!

This is an easy project that will enhance the appearance of your property.

Difficulty:

Easy

Instructions

Things You'll Need

• paving stones
• rope
• trowel or similar tool
• sand or fine soil
• level and long board
• sand

1. Decide on the route you want your path to take. A curve is most attractive but don't wander too widely or people will be tempted
   to leave the path.

   With two pieces of rope lay out the sides of your path.

   Remember that an average pace is about 18 inches so your stones from centre to centre should measure 18 inches.

   Estimate how many paving stones you will need. For stability and wear, these should be at least 2 inches thick.

2. Lay out the stones along your marked path in the exact position where they will be placed.

   With a trowel cut down into the grass or soil around each stone.

   Dig out the soil for about an inch. Your stones should be slightly above ground to start as they will settle with time.

3. Lay each stone in place as you progress. The stone must lie level and firm.

   If you dig a little deeper so that you can put down a bed of sand, it will be easier to level your stone.

4. Use a level to straighten each stone.

   As you move down the path, lay a board from stone to stone and put the level on this to ensure that your whole path is level.

   Tamp in each stone and fill in around the edges with soil or grass.

   Sweep off your stones and your job is done.

5. If you find that your stones sink or rise over the years, simply lift them and add or subtract soil to level them once again.