How to Install a Car Alarm in a Mitsubishi 3000GT
The powerful Mitsubishi 3000GT is a customizer's dream and one of the first projects is installing a custom alarm. This project requires a clear understanding of car electrical systems and several hours. Installation requires working by feel when installing behind the tight confines on the dash and takes a lot of patience.
Other People Are Reading
Instructions
-
-
1
Open the alarm system and read the manual carefully. Open the hood and remove the positive battery cable. Locate an open area in the engine bay and mount the alarm siren. Run the wires to the firewall on the driver side.
-
2
Connect the alarm's power wire to the positive battery cable. Feed all of the wires through the hole at the far driver's side, below the power steering cylinder. Slide the driver's seat all the way back and raise the steering wheel. Reach under the dash towards the outside corner to find the siren and power wires. Pull the wires out from under the dash.
-
-
3
Attach the alarms power lock module to the power lock relay next to the fuse box. Drill a small hole in an empty dash slot for the LED light and snap it into place. Place the alarm control module on the floorboard and connect all of the wires.
-
4
Locate the starter wire in the steering column and attach the start disable relay. Connect the relay to the control module. Install the shock sensor and any additional options by following the manufacturer's instructions.
-
5
Ensure all of the wires are connected to the control module and reach under the dash, directly beneath the steering wheel. Find a heavy wire bundle and secure the control module to it with zip ties.
-
6
Reconnect the positive battery cable and test the alarm. Adjust the sensitivity levels as needed and secure any loose wires with zip ties.
-
1
Tips & Warnings
Many authorized alarm dealers hold specials that include free installation.
