How to Change the Belt on an Oreck Vacuum Cleaner

One of the things that will keep a vacuum from picking up dirt as expected is a worn belt. Here is how to change the belt on your Oreck vacuum cleaner.

Difficulty: Moderately Easy

Instructions

Things You'll Need:

• New belt
• Screwdriver

1. Unplug the cord from the electrical outlet.

2. 
   Vacuum side view

   Look on the side of the vacuum's power head and remove the screw.

3. Use a flathead screwdriver (or similar object) and lift the door so you can slide it forward.

4. Remove the installed belt.

5. Loop the new belt over the motor shaft ensuring one end is on the brush roll pulley.

6. Rotate the brush 3 or 4 times to check the fit. You do not want any of the belt overhanging or loose fitting.

7. Replace the door and the two screws. Tighten the screws and your vacuum should be ready for use.

Tips & Warnings

• Oreck vacuum's come with long warranties. Check for your nearest Oreck dealer before performing maintenance yourself.
• Never repair electrical equipment when it is plugged in.

Resources

• Clean and Sanitize Your Toothbrush
• Merge Two Households
• Using Aero Portable Beds

[ebnickiea]

on 9/12/2008 sounds easy enough. thanks

[purrfect1969]

on 9/12/2008 Never had to change a belt on a vacuum, yet. Sounds like something I may be able to do. Thanks for the info.

[vikki9]

on 9/11/2008 Good to know. Thank you.

[Desula]

on 9/8/2008 Thank you for the ideas on changing the belt on a vacuum cleaner.

[Susang6]

on 9/8/2008 sounds like you actually had to figure this out! You have many talents..this is good to know info. 5*