Things You'll Need:
- Papertowels
- String(at least 8 inches longer than the gun barrel)
- Nail
- WD-40
-
Step 1
Take one paper towel and roll it up like a cigar.
-
Step 2
Tie the string around the center of the rolled paper towel.
-
Step 3
Tie the other end of the string around the nail. ( A screw or other small household item can be substituted.)
-
Step 4
Spray a generous amount of WD-40 on the paper towel and bend the paper towel in half at the point the string is tied.
-
Step 5
Open the chamber of the shotgun.
-
Step 6
Drop the end of the string with the nail attached into the chamber and feed it down until it comes out the end of the gun barrel.
-
Step 7
Pull the paper towel through the gun barrel to remove burnt powder and rust.
-
Step 8
Repeat these steps until barrel is clean.
-
Step 9
After the barrel is clean of powder, pull a dry paper towel without WD40 through the barrel.
-
Step 10
Take a paper towel, apply small amount of WD40, and wipe off the metal on the outside of the gun.











Comments
soanyway said
on 11/27/2009 Cool. Not that we have a shotgun but I'm sure many people do! I have recomn'd you. Pay it forward to all! ;-) I gave you 5 stars to counter act the person that gave you one. I hate that! There is always 5* in every article!