How to Repair a Pressure Switch in a Water Well Pump

Fixing a water well pressure switch is a fairly simple process and nearly anyone with simple electrical skills can do it. Just keep in mind that you can find most pressure switches at nearly any hardware store and are not that costly to replace.

Things You'll Need

• Screwdriver
• Voltmeter
• New switch
• Wire nuts

Send to Phone

Brought to you by

Send to Phone

Please enter your 10 digit phone number only.

Send

A link to this article has been sent to the phone number provided.

Close

Reply HELP for help, STOP to end. Message and data rates may apply.

Instructions

1. Take off the cover of the old pressure switch. Most models of well water pressure switches have a cover that simply snaps off, but some require a screwdriver to loosen a screw first.

2. Check the pressure switch's settings against the printing inside of the cover. If that solves your issues you are done. If you are still having problems, move on to Step 3.

3. Turn off the power to the switch by flipping the breaker. Check to be sure that the power is off with a voltmeter.

4. Remove the old switch making sure you note which color wire is in what position. You may want to mark the wires with colored electrical tape so you know which switch location to reconnect the wires.

5. Bring the switch to the hardware store and find a replacement that covers the same pressure gradient as the switch you are replacing.

6. Install the new switch according to the manufacturer's directions. Be sure the mounting and wires are in the correct place. Use wire nuts and a screwdriver to complete the installation.

7. Flip the power back on to the switch and test to make sure it is working properly. Be sure the settings match what works for your system or what the manufacturer recommends.