Step1
Make the container a tool to separate the water into H and O. the container top should be pierced 7 with wholes, 4 for the screws ,1 gas output, 1 electric input ,1 water input .open the container make the wholes in it 's cover ,put a screw in a whole ,sleeve it with a pipe ,take 6 zip bands cut their head so their length will be 2 or 3 cm, insert three in the top of the screw between the sleeve and the screw ,and in the other side of the screw where the bolt is about to come another 3.
repeat the same for the three remaining screws.
tight a stainless steal clamp on a bolt and insert a wire brown color (+) beneath the clamp and bolt . tight a stainless steal clamp on a pipe ,insert blue (-) wire beneath the clamp and the pipe.
repeat action for 3 remaining pipes screws and bolts.
join the brown wires into one wire cover the edge with anti electric hazard tape to prevent electric hazard, do the same for the blue wires.
fit the rubber band to the wholes by placing the pipes of gas and water and electricity wires.
the water separator is ready.
see on you tube
http://www.youtube.com/v/QTYCfaw2_Fk&hl=en" type="application/x-shockwave-flash" wmode="transparent" width="425" height="355"
Step2
as the water seperator is ready we will proceed to combine this device to the motor put the hit resistans pipe edge inside the container threw it's rubber band you placed in it's whole on step 1 the other edge insert inssted of the gasolin pipe before the gasolin filter.so that the gas uprising from the device we made will get to the car engine.
actualy now after filling the container with water and combining the wires to the battery the car can go on water .
Step3
but if you want to take care of the refilling the water for this device engage the other pipe to the device threw the last whole and combine it to another container filled with water ,this container should not be hermetic close in order to let the water flaw out to the device.
if you like to buy the full guide www.TheWaterMotor.com
Novice 
