How to make a hemp jewelry board/tips to use

The board is so easy and convenient. You will learn how to make a adjustable board to make your hemp jewelry. Also how to use the board.

Difficulty: Moderately Easy

Instructions

Things You'll Need:

• A sturdy board about 24" x 3 1/2" x 3/4"
• Philips Screw(long enough to wrap at least two twines.
• Medium open-eye hook
• Philips screwdriver
• Nail
• Hammer

1. Find a board that is sturdy. at lease 2 1/2 " wide. I found mine at a job site my husband was working at. Make sure it is clean and no nicks. Sand

2. Add a hole 5" from the top of board with nail. Continue every inch to two inches to 5" apart. Bottom hole should be 2 1/2 " from edge.

3. Screw open-eye hook in holes to open them wider to fit. Screw one screw into bottom hole(this is stationary).

4. Make a over hand knot to make a loop. Hook your loop on the open-eye hook.

5. Pull the short middle short strings down and rap around twice around screw and tie a slip knot tightly. Knot will loosen, pull to tighten as you make your project.

Tips & Warnings

• Instead of a knot (Use loop) use a connector with prong if you use spring clasps.
• Parents assist children.

[michaelesx]

on 4/19/2009 This is terribly written. It makes no sense. Ever heard of proofreading before you post something?