How to Maintain Hoses for a Hayward Aquabug

The hose sections on the Hayward Aquabug are among the most important parts of the pool cleaner. If the hoses aren't properly assembled and connected to the Aquabug, the cleaner simply can't do its job. Check all hose sections periodically to be sure they are in good working condition and free of defects. Here's how to maintain the hoses.

Difficulty: Moderately Easy

Instructions

1. Recognize the most important hose section in the set, the leader hose. The female end of this section attaches directly to the cone assembly at the top of the Aquabug. The Aquabug spins around the cone assembly, and the leader hose should always remain attached to the Aquabug, even when you remove the cleaner from the pool.

2. Assemble the remaining hose sections. Each 3-foot-long section has one female and one male end. The male end of one hose section fits into the female end of the next. Make sure to push and twist the connections together tightly so they don't come apart when the cleaner is operating.

3. Check each hose section periodically for pin holes or splits in the plastic by pulling each section out of the water periodically while the pump is running and listen for a hissing sound when the section comes out of the water. This sound indicates an air leak. Replace any damaged section to keep the Aquabug functioning properly.

4. Check each cuff end of each hose section. Make sure the cuff is in good shape and the seal between the cuff and the hose is tight.

5. Store the hose sections straight when not in use. Disconnect each section and lay it straight in a protected storage area out of the sunlight. Do not coil the hose because this puts strain on the sections and shortens the hose's useful life.