How to install ceramic tile

It's amazing how a simple (and relatively inexpensive) project like tiling your backsplash can make such a difference in your kitchen. Not only will you spice up your sink area, you will protect it at the same time. Adding ceramic tile is easier than you think and you can do it in a weekend.

Instructions

Difficulty: Moderately Easy

Things You’ll Need:

• ToolS
• Tape measure
• Level
• Tile cutter
• Tile nippers/tile saw
• Goggles
• Notched trowel
• Rubber grout float
• Materials
• Waterproof mastic tile adhesive
• Waterproof grout
• Glazed wall tiles
• Latex gloves
• Plastic washers
• Screws (1-1/4" to 1-5/8")

1. If your countertop is tiled, plan the layout so the backsplash grout veins line up with the countertop grout veins. If you don't have a tiled countertop, start the first tile in the center of the base of the backsplash.
   
   
   Turn off the power to electrical outlets in the area where you are working. Remove electrical outlet covers.
2. Clean the area with warm water and allow to dry.
3. Apply the manufacturer's recommended adhesive with a notched trowel. Hold the trowel at a 45° angle and spread a thin (approx. 1/16") layer. Be sure to work in small 3' x 3' areas to prevent the adhesive from drying out
4. Lay the first tile in the center at the base of the backsplash. Position the tile using a slight twisting motion. Use a level to make sure the tile is square. Place a spacer on each corner of the first tile. Cut one end of the spacers off in order to fit them between the countertop and the bottom of the tile. Push the spacers into the adhesive.
5. Good idea: If you have to cut tile, mark the proposed cut on the glazed side of the tile corners. Don't mark on the clay side. The ink can be absorbed and bleed through to the other side.
   Working out from the first tile, continue laying the tiles in a row, flush to the spacers. Wipe off any excess adhesive that oozes up between the tiles. Leave enough space to fill in with grout. Occasionally check to make sure the tiles are level. After one row is complete, begin with the next row and follow the same pattern. Apply adhesive as needed.
6. If you need to cut tiles, score the tile with a tile cutter. Be careful not to score the area of the tile that will show. Use tile nippers or a saw to cut away the area carefully.
7. When you place the tiles around an outlet, be sure that the outlet cover hides the tile edges. Continue tiling as usual.
8. When you have laid all the tiles, wipe off any excess adhesive with a damp cloth. Use a rounded stick to clean between the tiles.
9. Allow the adhesive to set according to the manufacturer's instructions. After the adhesive sets, remove the spacers.
10. Mix the grout according to the manufacturer's instructions. Since grout may irritate eyes and skin, wear safety goggles and latex gloves. Apply the grout using a rubber float. Spread the grout diagonally at a 45° angle across the tiles, packing the grout between the tiles. Wipe off the excess grout with a damp sponge when the grout becomes firm.
11. Shape the grout joints using a rounded stick. Clean the tiles again and smooth joints with a damp sponge.
    
    
    After the grout dries and a haze forms, wipe off the tiles and shine them with a clean cloth.
12. Replace the electrical outlets and switches. You will need longer screws to replace the outlets covers. Use a 1-1/4" to 1-5/8" screws with plastic washers behind the outlet to bring the outlet out flush with the tile.