Things You'll Need:
-
Step 1
Cut four equal lengths of embroidery floss.
-
Step 2
Knot the four pieces of embroidery floss together. Make sure the knot won't slip while braiding your bracelet.
-
Step 3
Tape the threads on a flat surface and spread them out. The threads will be numbered from left to right 1, 2, 3 and 4.
-
Step 4
Take thread 1 and lay it over thread 2. Wrap the end of thread 1 under thread 2 and over the top section of thread 1. Pull tight.
-
Step 5
Repeat step 4 again so that you have two knots on thread 2. Then do the same step one time each for thread 3 and thread 4. When you are done, thread 1 will be at the end where thread 4 was at the beginning.
-
Step 6
Repeat steps 4 and 5 for wrapping thread 2 around threads 3, 4 and 1.
-
Step 7
Repeat steps 4 and 5 for threads 3 and 4 as they move to the far left position. You will start to see diagonals of color through the bracelet.
-
Step 8
Repeat steps 4 through seven again to go through all the colors until the bracelet is as long as you need to make it.
-
Step 9
Knot the end of the embroidery thread off.
-
Step 10
Trim the ends of the embroidery thread off so that it is all even.









