How to Build a License Plate Birdhouse

A license plate birdhouse is a quick and easy project to build with kids. It is meant for small birds and requires little maintenance.

Things You'll Need

• License plate
• 1-by-8-by-4 inch cedar
• 1 1/4-inch deck screws
• Galvanized nails
• 1 1/8-inch drill bit
• 1/4-inch drill bit

Instructions

1. Cut the sides of the birdhouse to 4 inches high and 6 1/4 inches wide. Make a 45 degree bevel on the top.

2. Build the front of the license plate birdhouse 7 inches wide by nine inches tall. Create a peak that is at a 45 degree angle.

3. Create a hole on the front for entrance into the birdhouse. Use the 1 1/8 inch drill bit and drill the hole 4 inches from the bottom.

4. Drill a hole for the perch. Drill the hole 1 inch below the entrance hole using the 1/4 inch drill bit.

5. Make the back of the license plate birdhouse. It should be 7 inches wide by 9 3/4 inches tall with a 45 degree peak. Trim the bottom of the birdhouse to 6 1/4 inches wide by 7 inches tall.

6. Assemble the pieces together using galvanized nails or screws. Only 1 inch of the bottom will jut out for a railing. Apply a weatherproof sealant.

7. Fold the license plate in half to crease it. Lay it on top of the birdhouse and nail or screw it down so it will resemble a steel or metal roof.

Resources

• Read this Article in Spanish