How to skin a snake

this is how to skin a snake

Instructions

Difficulty: Moderately Easy

1. Remove the head, unless it is to be used for taxidermy purposes. It is always best to work with a decapitated snake because even "dead" snakes have been known to strike, and the fangs are still quite dangerous. By removing the head, you are removing all venom.
2. Wash the outside of the snake thoroughly. Soapy water or even plain water will work well. Just make sure the soap is completely rinsed off of the snake.
3. Make an incision down the centerline of the belly, through the skin only, all the way from the stump where the head was attached to the base of the rattle. On most snakes, there is a smaller belly scale covering the cloaca. In the picture, this is the last cream-colored scale before the darker tail scales. Simply split this up the middle just like the rest of the scales.
4. Pull the skin from the flesh by hand, again beginning at the head end, using even tension on the skin to avoid tearing. Be sure to separate the skin from the membrane underneath right at the head end. You want clean skin with nothing attached to it. The hide should be loose enough that it easily detaches from the carcass. If the skin is a bit "tight", a knife may be used to carefully free it in the tough places. Peeling without the use of a knife can usually be accomplished all the way to the cloaca.When the cloaca is reached, it is usually necessary to free it from the skin by cutting around the opening with the knife. Continue skinning to the base of the rattle. The attachments to the muscles that control the rattle generally make the hide harder to pull off. A knife must be used in this area if the skin is too tight to peel off, as the skin is rather delicate in this section.
   After the skin is completely freed from all but the rattle itself, cut through the tail as close to the base of the rattle as possible. If the skin is to be saved with the rattle attached, it helps for the piece of flesh attached to the rattle to be small.
   Don't fret too much about totally removing the flesh below the cloaca and above the rattles (basically the black and white banding on rattlesnakes). It is almost impossible to completely remove the skin from the flesh in this area. It will dry up easily.
   Constrictor snakes such as bull and rat snakes cannot be "peeled". Their skin is attached with many muscle attachments over the full length of the body. Cutting through them is tedious as it is hard to get the skin free from the flesh and very easy to cut or tear the skin.
5. Remove the viscera (innards) by hand, starting at the head end, using a scooping motion with the hand if the organs are difficult to remove. Care must be taken near the lower digestive region or the snake might excrete unappetizing substances on the meat.
6. Rinse the now eviscerated and skinned snake in cool water to remove any excess blood or other undesirable substances. Membrane and fat are often rather difficult to remove from the ribcage and backbone and can be cut free at this time.
7. Cut the snake into segments that are the most convenient length for the desired method of cooking.

Tips & Warnings

• When dealing with a fresh (not previously frozen) snake, it is best to wait an hour or two before skinning after the snake is killed. It is amazing how much a dead snake can wiggle, and this makes it difficult to make a straight incision.
• A simpler way to skin a snake is to remove the head and carefully peel the skin over itself like pulling a sock off your foot by pulling from the top. Sprinkle the skin with borax to cure it, around a week. You can then sew or glue it onto a hat or belt. The advantage to this is that you can't accidentally pierce the visceral sac, that scales are not broken and it is a more finished look when stitching the skin onto something.
• Some people prefer to soak the ready-to-cook snake pieces in saltwater for a day or two to remove any remaining blood or "gaminess" from the meat.
• Snakes can safely be frozen; the meat is not damaged and the coloration of the skin is not affected.
• When cutting the snake into segments, make the cuts between and at the same angle as the ribs to avoid cutting the ribs. If the ribs are severed, they may be difficult to remove from the meat after it is cooked
• Snake is somewhere between chicken and fish in texture and flavor, and may be made to seem like either.
• If the snake was bitten by itself or by another venomous snake, cooking will usually remove all venom.[3] If you see any bite marks, however, proceed with caution.
• Be careful when handling or dispatching any snake, particularly venomous species. If you are bitten by a snake, particularly a venomous one, seek medical treatment immediately.
• Observe all local laws governing the capture of wild snakes.
• Be careful with the knife!
• Reptiles are known to spread Salmonella. Be sure to wash hands after handling.