How to Install Batts of Insulation
When remodeling or building new structures it is important to make them as energy efficient as possible. One area of concern is conserving on the heating costs. A way of cutting the heating costs is to install extra insulation in the ceiling and walls. Insulation is sold in batts and is easy to install yourself. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Measure the length of insulation that you need to reach from the ceiling to the floor at one edge of the wall you are going to insulate.
-
2
Unroll the batt of insulation and measure a piece that is the same dimension as what you will need to reach from the ceiling to the floor. Cut it with the razor knife.
-
-
3
Position the ladder next to the wall so that you may lift the strip of insulation to the ceiling. Make a nice tight fit with no air gaps or open space.
-
4
Staple the strip in place on both sides of the strip. Place a staple every foot or so into the stud on either side of the space where the insulation is being placed.
-
5
Move the ladder to the next space for insulation to be installed and repeat Steps 1 through 4.
-
1
Tips & Warnings
Tightly packing the insulation will decrease the amount of heat loss you will experience.
If you have extra small pieces left over they may be used in other places in your house or tossed into the attic to help insulate the roof.
Care should be taken when handling insulation. It is made of fiberglass and will penetrate skin. Use gloves when handling it and keep a shirt on to minimize skin exposure.
