How to Install a Yamaha R1 Battery
The Yamaha R1 is one of the fastest bikes in the world. The R1 enhances the power and the frame balancing of this two-wheeler. Read on to learn how to install a Yamaha R1 battery.
Other People Are Reading
Instructions
-
-
1
Turn off the ignition of the bike.
-
2
Release the main and passenger seats of the bike.
-
-
3
Pull the front of the fuel tank upwards.
-
4
Place the battery in the tail section. Arrange the wires under this section and move towards the front of the bike.
-
5
Unplug the connector from the stock wiring harness and injector rail inside the tail section.
-
6
Join the connectors of the battery to the connector unplugged from the wiring harness. Bring the fuel tank back to its original position.
-
7
Open the two bolts on the left and right side of the battery holder bracket with a screwdriver. Make sure that there is enough space to place the battery underneath it.
-
8
Connect the negative side of the battery to the ground wire of the battery.
-
9
Clean the surfaces of the rear section of the trunk.
-
10
Install the battery in the trunk using the Velcro strip that has been supplied with the unit. Connect all the wires.
-
11
Secure the bolts of the bracket.
-
12
Position the main and the passenger seats to the original position.
-
13
Go for a test-ride to check that the battery is properly installed.
-
1
Tips & Warnings
Read the instruction guide carefully before installing the battery.
Do not install the battery until you have switched off the ignition.
