How to Set up the Cobra 25 NW ST CB Radio in a Home

Setting up the Cobra to operate in a home is an acceptable practice. Be sure to follow these guidelines to maintain safety and optimum performance:

Difficulty: Moderately Easy

Instructions

1. Locate the transceiver's red and black leads.

2. Connect these red and black leads to the red and black terminals on the power pack (see note below on requirements for the power pack).

3. On the back of the CB Radio, locate the unit marked 'Power'. Plug the power cable into this unit, being careful to line up polarity markings.

4. Attach the appropriately installed and matched base station antenna.

Tips & Warnings

• Before setting up your CB Radio at home, be sure that you have a 13.8 volt DC Power Pack that is rated at least two amps.
• Also, be sure that the base station antenna is properly installed before beginning the set-up procedure.
• Do not, under any circumstances, connect the transceiver directly to 120 vac.