How to Insert a Battery in a Palm Tungsten E2

Inserting the replacement battery for the Palm Tungsten E2 isn't a problem if you use the placement and orientation of the original battery as a map. The only trick is getting the case open without damaging the screen or your fingers.

Difficulty: Moderate

Instructions

Things You'll Need:

• Palm Tungsten E2
• Star-bit screwdriver
• New tungsten E2 battery
• Prying tool
• Glue

1. Place the Tungsten E2 on a flat surface, with the display facing down.

2. Remove the screws from the back of the case using a star-bit screwdriver.

3. Loosen the 2 halves of the case with the edge of a standard screwdriver.

4. Separate the case halves. Find the battery and carefully note how it lies in the case.
   

5. Disconnect the battery from the motherboard, and then work the battery loose from the device.

6. Put a dab of glue on the battery. Insert the new battery in the E2. Allow the glue ample time to dry.

7. Connect the power supply lead to the battery.

8. Seal the 2 halves of the case, then replace and tighten the screws.

Tips & Warnings

• Make sure you have a well-lighted workspace. Working with tiny components in dim lighting conditions puts unneccessary strain on the eyes.
• Consider getting a qualified service technician to replace your E2's battery if you are not comfortable working with electronic devices.
• Do not open the case of your E2 while the power is on.