How to Install RAM in an iMac

Installing RAM in iMac is easy if you follow the proper procedure. The RAM that you currently have may not be sufficient. To install a new RAM, you first need to remove your old RAM. This task takes a little time.

Instructions

Difficulty: Moderately Challenging

1. Shut down your computer and turn the power off.
2. Unplug all the cables as well as the power cord. If your modem is connected to the phone line, remove it as well.
3. Place your computer on a soft dry cloth. This will prevent damage from any rough surface.
4. Lift the computer assembly with both hands and gently place it in such a way that the monitor faces downward on the soft cloth.
5. Use a screwdriver to unscrew the lower back panel of the iMac. Hold the plastic cover and gently tug to remove it once it is unscrewed. Keep the cover aside.
6. Touch the exposed metal surface on the logic board or drive assembly to disperse static electricity.
7. Disconnect the cables below the clamps. If the clamps have screws, unscrew them before removing the cables. Disconnect all the cables attached to the main logic board. Once the cables are removed, you will see a plastic handle with two screws.
8. Unscrew the two screws from the plastic.
9. Get the logic board out by pulling the plastic handle gently. Keep the logic board aside on a surface covered with a soft cloth.
10. Remove the metal shield below the logic board by lifting it with both hands.
11. Align your RAM to fit into the slot provided below the metal shield. Make sure the RAM is safely put in its slot as it makes a “snap” sound. Start the assembling process.
12. Put the metal shield back in its position. Hold the main logic board with its plastic handle and slide it back to the original position. Screw the two screws back into the plastic handle.
13. Reconnect the cables you removed earlier to the logic board. Tuck the cables below your clamp and put screws back in the clamp.
14. Replace the plastic cover and re-insert the screws that you had removed earlier.
15. Connect your cables and power cord.
16. Switch on your computer to check the new RAM.
17. Check the installed memory on your iMac. Begin using your computer.

Tips & Warnings

• Print a copy of these steps before starting your operation, since your computer will be unplugged at the time.
• Use the handle provided at the bottom to operate comfortably.
• Keep the screws in a secure place for reuse.
• Use s screwdriver to remove video cable, if required.
• Wear an anti-static wristband during the process.
• Do not use a powered screwdriver. They tend to damage the screws.
• Do not touch the edge connectors of your RAM at any point during the installation process.
• Do not start the installation process immediately. Wait a while until your computer parts cool down to room temperature.

Who Can Help:

• Find Computer, Electrical and Telephone Services Here. Compare Up to 4 Quotes, Free Service & No Obligation.
• Find Electrical Services Here. Compare Up to 4 Quotes, Free Service & No Obligation.