Troubleshooting the Blower Fan on a 2003 Rendezvous


The 2003 Buick Rendezvous was equipped with a 3.4-liter V-6 in both the CX 2WD and CX AWD models. The blower motor is controlled by either a manual dial on the heater control panel or an automatic speed controller in the digital control panel. The blower motor controls the volume of air movement in the Rendezvous cabin. Testing and replacing the blower motor requires removal of interior body panels, as well as electrical testing equipment.

Things You'll Need

  • 3/8-inch-drive ratchet
  • 3/8-inch-drive socket set
  • Flat-head screwdriver (optional)
  • Multimeter
  • Sit in the Rendezvous driver's seat and turn the engine on. Set the fan speed selector to the lowest setting. Move the fan speed from the lowest to the highest setting, one step at a time. If the blower motor works on some but not all settings, the heater control panel or the blower motor control processor are faulty and need to be replaced. If the blower motor does not work at any setting, proceed to Step 2.

  • Turn the engine off. Move to the passenger side of the Rendezvous and open the door. Kneel next to the passenger seat so that you can access the underside of the dashboard. Remove the right-hand side insulator panel screws from below the dashboard, using a ratchet and socket. Remove the insulator panel from the Rendezvous and your work area.

  • Disconnect the electrical connector from the blower motor, using a flat-head screwdriver on the locking tabs if needed. Turn the Buick's engine back on while sitting in the passenger seat. Turn the fan speed and heat to their highest settings.

  • Turn the multimeter indicator dial to the volts setting. Insert the probes from the multimeter into the electrical connector. If you receive no voltage reading, there is an electrical malfunction between the blower motor fuse, resistor and control processor. If you receive a voltage reading, the blower motor is bad and needs to be replaced.

  • Installation of the blower motor electrical connector and insulator panel are the reverse of the removal processes. Tighten the insulator panel screws snug with a ratchet and socket.


Promoted By Zergnet


Related Searches

Read Article

How to Clean Your Car Headlights

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!