How to Install PVC Pipe on the Top of a Fence to Keep Dogs From Jumping

How to Install PVC Pipe on the Top of a Fence to Keep Dogs From Jumping thumbnail
A dog cannot grip a spinning pipe if he tries to jump over the fence.

An untrained dog may jump over a fence for a sense of freedom, to play, or to chase squirrels and other animals. Until he learns that he can find praise, rewards and amusement in his home and yard, you may need to install a PVC pipe over your fence as a preventative measure. If your dog tries to jump the fence, he won't be able to grip the spinning roller pipe and, therefore, won't be able to escape.

Things You'll Need

  • Miter saw
  • Carriage bolts
  • 3/16-inch cable wire
  • 2 end brackets
  • Eye hooks
  • Wire rope locks
  • Box wrench
  • Wire cutters
  • Screwdriver
Show More

Instructions

    • 1

      Measure the length of your fence and then measure the PVC roller pipe to the length of your fence. Use 1/2-inch diameter PVC pipe for the inner roller and 1-inch diameter pipe for the outer roller.

    • 2

      Cut the measured PVC pipe with a miter saw with a 7 1/4-inch blade and about 40 teeth. Cut the plastic piping lengthwise in sections of 5 feet plus about 1/2 to 3/4 inch for the tubes to spin freely.

    • 3

      Scrape the burrs from the cut ends of the PVC pipe with a sharp knife to avoid any obstruction.

    • 4

      Mount 5-inch looped carriage bolts to tie down the cable wire at 5-foot intervals on the fence with a screwdriver. Using a screwdriver, mount the two end brackets with the "L" facing toward the center of the cable.

    • 5

      Mount the cable wire parallel with the top of your fence line. Use eye hooks for support at intervals of 10 feet or less.

    • 6

      Thread the wire rope through the 1/2-inch PVC. Slide the 1-inch PVC over the 1/2-inch PVC. Feed the wire through the next carriage bolt. Continue the process to install PVC pipe over the entire fence.

    • 7

      Push the cable through the loop on the carriage bolt at one end of the run and anchor it with wire rope lock.

    • 8

      Pull the wire tightly through the last bracket. Lock down the ends of the wire rope tight enough to prevent your dog's weight from pulling it loose. Tighten the bolts on the wire rope locks with a wrench, allowing enough tension to keep the PVC pipe up and spinning above the fence.

Tips & Warnings

  • A hack saw or other fine tooth saw for cutting PVC pipe might gum the saw and not cut effectively.

Related Searches

References

Resources

  • Photo Credit Jupiterimages/Photos.com/Getty Images

Related Ads

Featured
View Mobile Site