DIY Shower Head Water Softener

Save

In some areas, water contains large concentrations of minerals. This is known as hard water. Hard water makes it difficult to rinse soap off your body or hair in the shower, and can leave a film residue on shower walls. Adding a filter to the shower head can greatly soften this water by removing minerals and chemicals such as chlorine. Adding a filter will also improve the overall performance of your shower by reducing the amount of mineral buildup on shower nozzles.

Things You'll Need

  • Cotton rag or hand towel
  • Wrench or pliers
  • Carbon shower filter
  • Place a cotton rag or hand towel over the nut above the shower head. This will prevent tools from marring the surface of the shower arm.

  • Place an adjustable wrench or pliers over the cloth where the nut is located. Turn the nut counterclockwise until the shower arm pulls free from the connection in the wall.

  • Align the input side of a carbon shower filter into the hole in the wall where the shower arm was located. Turn the filter clockwise by hand until tight.

  • Place the shower arm into the output side of the filter and turn the nut on the arm clockwise, by hand, until tight. Place the cloth or rag over the nut and finish tightening the nut with a wrench or pliers.

  • Turn on the shower and allow the water to flow for at least 30 seconds. The water may come out black for a few seconds. This is because the carbon dust inside the filter is purging. The water should clear up within a few seconds.

Tips & Warnings

  • Most carbon shower filters contain carbon pellets that should be replaced every six months. To replace the carbon, unscrew the front of the filter and remove the old carbon media. Place a new bag of carbon inside the filter and tighten the two sides together again.

Related Searches

References

  • Photo Credit Thinkstock Images/Comstock/Getty Images
Promoted By Zergnet

Comments

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!