How to Remove Particle Board Stair Treads
Particle board is commonly used on stairs for the tread, or area that is stepped on. It is held in place by nails, screws and adhesive to the stringers, the jagged cut pieces on the side of the stairs, and the risers, the pieces that are at right angles with the treads. Particle board stairs are often used under carpeting. Generally, you'll remove particle board treads to replace them if they are broken or to remodel the stairs from carpeting to hardwood flooring. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Tear the carpet up from the stairs, exposing the particle board treads.
-
2
Start at the topmost stair. Pry up any nails holding the stair tread to the stringers and the riser, using a pry bar and a hammer.
-
-
3
Unscrew any screws that hold the tread to the riser using a screwdriver.
-
4
Break the adhesive bond between the stair tread and the riser and stringers using the pry bar and hammer. Place the tip of the pry bar under the lip of the tread. Hit the end of the bar with the hammer to drive it between the tread and the riser, lifting it up. Move the pry bar across by about 4 inches and repeat.
-
5
Pry the tread up all the way around until you can lift it up without any trouble. Repeat with any other steps that you want to remove the particle board stair tread.
-
1
Tips & Warnings
You might not have to remove the particle board tread to install hardwood stairs. Some wood stair veneers are quite thin and adhere well to particle board. Check with your flooring consultant before tearing up the stairs.
Wear gloves and eye protection when removing particle board stair treads.
References
- Photo Credit Jupiterimages/Photos.com/Getty Images
