How to Insulate a Split-Level Basement
Split-level houses combine a two-level story with an attached single-story structure. One part of the house may have a full basement, and the other a crawlspace. Insulating basements requires attention to moisture, as it comes from inside and outside. Exterior walls should be dampproofed and insulated before the interior is insulated, so that moisture is allowed to escape to the interior as the concrete cures. Overall, when applied correctly, insulating the basement can improve moisture control and air quality for the house, reducing the potential for mold growth, and creating a more comfortable environment. Does this Spark an idea?
Other People Are Reading
Things You'll Need
- Extruded polystyrene board (foam board), 2-inch
- Utility knife
- 2-by-4 lumber
- Fiberglass batt insulation, minimum R-12
- Polyethylene (poly) sheeting, minimum 4-mil
- Polyethylene (poly) sheeting, minimum 6-mil
- Staple gun and staples
- Acoustic sealant
- Tape for sealing poly, Tuck Tape or similar
- Caulking
- Caulking gun
- Foam-in insulation (optional)
- Gypsum board, or another fire-resistant material
Instructions
-
-
1
Install extruded polystyrene board vertically on the exterior of the foundation wall, from the finish grade line to at least 2 feet depth below grade. Backfill to the top of the board.
-
2
Lay the foam board against the interior basement foundation walls for the full height. Build a stud wall with the 2-by-4 and install against the wall. Fit fiberglass insulation snugly between the studs.
-
-
3
Use the staple gun to seal the entire wall with 4-mil polyethylene material. Cover the penetrations of the staples, and any tears or cuts, with the tape or acoustic sealant. Finish the wall with gypsum board, or another fire-resistant material.
-
4
Friction-fit foam board into the cavities of headers. Seal gaps with caulking or foam-in insulation.
-
5
Insulate the heated crawlspace with the polystyrene board for the full height of the walls. Add foam board to the joist rim, and to the joists for the floor above.
-
6
Close off vents after insulating heated crawlspace walls. Place 6-mil poly sheeting over the ground or concrete. Overlap seams, and use stones to weigh it down. Seal the edges.
-
7
Increase the insulation for the floor above an unheated crawlspace to R-20. Install the 6-mil poly to the crawlspace floor.
-
1
Tips & Warnings
Insulate basement walls to at least R-20 if the home uses electric heat.
Extruded polystyrene board acts as a vapor retarder.
Foam board has to be covered from sunlight.
Perforated poly facing on fiberglass insulation keeps air in, but allows water vapor to escape.
Don't add interior insulation until moisture issues are fixed around the foundation. Trapped moisture causes serious problems.
References
Resources
- Photo Credit Comstock Images/Comstock/Getty Images
