How to Back Flush a Shallow Point Well

Save

A hand-drilled shallow point well can provide homeowners with an economical water supply. Over time, you may notice reduced water flow coming from your well. To improve your well, you need to clean the well screen. Back flushing clears any accumulated particulates from around the screen. The most common way to back flush a shallow point well is surging, which forces water in and out of the well system.

Things You'll Need

  • Surge block
  • PVC pipe
  • One-way valve assembly
  • Clear vinyl tubing
  • Clamp
  • 5 gallon bucket
  • Attach the surge block to a section of PVC pipe. A surge block functions like a plunger.

  • Insert the PVC pipe into the well casing. Lower the pipe until the surge block reaches the bottom of the well. Add additional sections of PVC pipe as needed and secure each section with vice grips. Leave 2 to 3 feet of pipe above the well casing.

  • Connect a one-way valve assembly to the PVC pipe. Attach a 6 to 7 foot length of clear vinyl tubing to the valve assembly. Clamp the other end of the tubing to the side of a 5-gallon bucket.

  • Raise and lower the surge block 2 to 3 feet at a time to draw water into the connecting tubing. Use a fast downward stroke and a slow upward stroke.

  • Repeat the process until the water coming out of the well is clear.

Tips & Warnings

  • Use a certified well contractor.
  • Do not reintroduce particulate matter into the well.

Related Searches

References

Promoted By Zergnet

Comments

Resources

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!