How to Get the Heater on a Nordyne E1EH-015HA Unit to Work
The Nordyne E1EH-015HA and E2 furnace series are both downflow electric furnaces with air-conditioning capacity, baked enamel appliance doors, insulated cabinet protecting against heat loss, and nichrome-staged heating elements designed to increase overall heating efficiency and effectiveness. If the furnace is not heating, troubleshooting identifies the problem and solution. Does this Spark an idea?
Things You'll Need
- Dishwashing liquid
- Water
- Clean cloth
- Vacuum cleaner with brush attachment
Instructions
-
-
1
Verify that the Nordyne furnace is connected to a working power supply and the primary furnace power switch is set to “On.” Reset or replace the fuse or circuit breaker if needed.
-
2
Turn the thermostat fan switch to “Auto” or “Heat,” and then turn up the thermostat temperature if the furnace is connected to a working power supply but is not heating.
-
-
3
Push the access door on the furnace completely closed. The furnace does not operate if the access door is open.
-
4
Disconnect the furnace power and open the access door. Remove the air filter if the furnace continues heating poorly. Remove the coil filters and wash them with soapy water. Rinse them well and set them aside to dry. Replace the filters.
-
5
Wipe down the furnace cabinet and the inside an exterior with a clean cloth to remove dust and lint.
-
6
Vacuum the blower motor with a vacuum nozzle attachment. Close the access panel firmly and restore power. Set the thermostat to “Heat” and the desired temperature.
-
1
Tips & Warnings
Contact Nordyne or another qualified service professional for service if the troubleshooting steps do not resolve the problem and the furnace continues not to heat.
