How to Display Malfunction on a Wavetek 9100

Display malfunctions on a Wavetek 9100 will prevent you from starting the calibrator.

A Wavetek 9100 is a specific type of Fluke calibrator designed to gauge specific amounts of pressure. A display malfunction with regards to a Wavetek 9100 can be detected by observing a series of light patterns and words during the start-up of the device itself. Display malfunctions often require professional maintenance and a return to the manufacturer.

Instructions

1. Turn on your Wavetek 9100 by holding down the Start button.

2. If your display is malfunctioning, the words "Run UUT" and "Disk Access" will flash continuously on the screen.

3. While these words flash, there will be no VFD display on the screen. This display will normally turn on when your display is functioning properly.

4. This malfunction indicates that there is no communication between the U12 on the main board and the display processor.

Tips & Warnings

• If your Wavetek 9100 display is malfunctioning, turn the system off and send it back to the manufacturer.

References

• X Mission: Fluke 9100 TL1 Reference Manual