How to Put a Spring on a Craftsman Discharge Chute

Save

If the discharge chute on your Craftsman mower doesn't go back over the discharge opening once you stop the mower, it is most likely because of a broken or faulty spring. The spring attaches to a metal rod under the mower and pulls the chute down. Putting a spring on a Craftsman discharge chute does not require removal of the chute. Replacement springs are available through Sears and some home improvement centers.

Things You'll Need

  • Vise grips
  • Pliers
  • Unplug the spark plug wire from the spark plug. Place the Craftsman mower on a hard, level surface like the driveway or the floor of your garage.

  • Lift the discharge chute and clamp a pair of vise grips on the upper right edge of the discharge opening. This enables the chute to remain pointing up while you are replacing the spring.

  • Unhook the long end of the spring from the tab on the inside of the chute. Grab the middle of the long portion to pull the end out of the tab.

  • Grab the top hub of the star washer securing the spring to the chute shaft with a pair of pliers. The chute shaft is the metal rod that runs through the back-end of the chute. The spring attaches to a small L-shape rod protruding from the chute shaft.

  • Pull the star washer off the L-shape rod with the pliers. Slide the end of the spring off the rod. Slide the loop end of the new spring over the rod. The hook on the opposite end of the spring should point to the rear of the Craftsman mower.

  • Push the new star washer that comes with the spring over the L-shape rod until it is against the loop end of the spring. Hook the opposite end of the spring into the tab on the chute. Remove the vise grips and push the spark plug wire back over the spark plug.

Related Searches

References

Promoted By Zergnet

Comments

Related Searches

Check It Out

How to Make a Vertical Clay Pot Garden

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!