How to Install a Miele 4062-14
Adding a Miele 4062-14 coffee system adds more functionality to your kitchen without the need for hooking up water lines or hard-wiring anything to your home electrical system. The unit uses a power cord like most other appliances and water is added to the system as necessary. The Miele coffee system installs much like a built-in oven. Once you have the opening built, installing a Miele 4062-14 is a matter of leveling the unit and ensuring it's not pulled out of the cabinet. Does this Spark an idea?
Instructions
-
-
1
Peel the adhesive backers off the four sealing strips. The strips are foam and cut to the exact size of the four sides of the Miele coffee system.
-
2
Position the strips behind the trim flanges on all four sides, with the adhesive against the flange. Push down on each strip with your fingers, then slide your finger across the length of the strip. This helps ensure good adhesion of the strip.
-
-
3
Place the unit on its back with the leveling feet pointing toward you. Turn the feet with a wrench so the top of the feet are 1/16 inch from the bottom. Turn the coffee system upright and place it on a level surface. Place a level across the top to ensure the unit is level. Adjust the feet as necessary until the unit is level.
-
4
Lift the Miele coffee system into the cabinet opening, threading the power cord through the hole in the cabinet. Push the coffee system into the cabinet fully.
-
5
Open the coffee system door and locate the four holes for the securing screws. There are two holes on each side of the unit.
-
6
Install the lower screws to center the unit in the opening. Install the two upper screws and tighten them with a Phillips screwdriver. Plug the power cord into the outlet in the cabinet.
-
1
