Balboa spas and hot tubs operate with a safety feature known as a water pressure switch, which activates the heater when water flows through the internal plumbing. When the hot tub is not in operation, the switch shuts off. This prevents the equipment from overheating. If the Balboa will not heat at all, try troubleshooting the pressure switch with an ohmmeter to determine if it is defective. This basic diagnostic test takes less than 15 minutes.
Things You'll Need
- Wrench set
Shut off the Balboa at the control panel on the edge of the tub. Pull down the handle on the electrical box connected to the hot tub with a conduit. This shuts off electricity to the unit while you troubleshoot the pressure switch.
Open the service door at the base of the Balboa. Turn the handle clockwise and pull it to open. The pressure switch is in the right corner at the bottom.
Loosen and remove the two nuts on the contact bolts at the side of the switch. Slide off the looped metal connector on the end of each wire from the two contact bolts. Make a note to remember which wire attaches to which bolt.
Attach the clips on the ohmmeter wires to the two contact bolts on the pressure switch. If the ohmmeter displays a zero reading, turn the adjustment knob on the top of the switch clockwise until it clicks to the next position. If the ohmmeter does not register any reading after testing the switch at every pressure position by twisting the adjustment knob in increments, then the switch is defective and must be replaced.
What Is the Purpose of a Hot Tub Pressure Switch?
Hot tubs and spas have pressure switches to protect the heating system from damage if other mechanisms fail or malfunction. Pressure switches...
How to Set Jacuzzi & Hot Tub Timers
Jacuzzi and hot tub timers are designed to be simple to adjust and very user-friendly. This allows you to quickly adjust the...
How to Operate a Catalina Spa
Owning a spa provides you with an opportunity to relax and soothe aching muscles. Though many people own a spa, learning to...
How to Adjust a Spa Pressure Switch
A spa pressure switch operates underwater pressure to turn the heater on and off. If there is not enough water in the...