Concrete blocks are often used instead of poured concrete for foundation walls in houses. Properly installed, reinforced and with grouted openings in the blocks, they are as solid as poured concrete. They are often used because they can be less expensive than building wooden forms and pouring concrete. Blocks are more porous than poured concrete and need to be properly sealed against moisture and insulated against heat and cold. The best insulation for a concrete block basement combines interior and exterior insulation. The best choice for insulating the exterior face of a concrete block wall is some type of rigid foam board.
Things You'll Need
- Rigid foam board
- Moisture barrier
- Construction adhesive or mechanical fasteners
- Foam board sealant
- Loose granular fill material
Cover the concrete block wall with a good moisture barrier; some type of liquid asphalt or cement-based sealant is often used, but a tar paper or similar membrane also can be used. Seal the wall from the footing to above the ground level on the concrete blocks so no water can come between the wall and insulation. Let any moisture barrier dry thoroughly before installing foam board.
Install rigid foam board with construction adhesive or mechanical fasteners. Dow, the creator of Styrofoam and a major insulation manufacturer, recommends securing foam board panels with concrete fasteners long enough to penetrate the foam and 1 1/2 inches into the block, with 1-inch corrosion-resistant washers on the head. Use two fasteners per board a few inches from the edge of the board. Some installers spread construction adhesive on panels and press them firmly into place until the adhesive sets.
Rest the insulation panel on top of the concrete block wall footing and make sure it extends at least above the expected finish grade of the outside dirt. Seal the top of each panel with a sealant compatible with the foam board to prevent water from getting in through the top. Butt panels tightly together; seal the seams with a compatible tape if possible.
Place boards with grooved faces outward if they have grooves; these divert water down the panel into a drainage channel normally installed around the footing. Cover the bottom of the exterior foam board panels with several inches of some type of loose granular material to allow water to drain away.
Tips & Warnings
- Choose a type of rigid foam insulation impregnated with boric acid to resist insect damage. Use extruded polystyrene for most applications; it has a high heat resistance or "R" value, strong compressive strength so it will not break under pressure such as dirt backfilled against the wall and excellent resistance to moisture, which makes it good for underground use.
- A coat of waterproof paint on the interior of a block foundation is also recommended.
When Is it Too Cold to Pour Concrete?
The hardening of concrete is a chemical reaction that requires certain conditions and temperatures. Ideally, concrete should be poured when the air...
How to Insulate Exterior Walls
Insulating exterior walls is an easy do-it-yourself project if you're working with a new construction, a room addition or if you're installing...
How to Install Foam Insulation to Concrete Blocks
Even though concrete blocks are thick, they are not good insulators. If you plan to heat a space with concrete block walls,...
The Installation Process of Polyisocyanurate Foam Boards
Polyisocyanurate foam is a form of closed-cell insulation that you can spray in place or install as a prefabricated board. The effectiveness...
What Is the Rough Cost of Concrete Building Block?
Concrete blocks are a relatively inexpensive, durable building material. They hold up well in most climates and can be installed with minimal...
Exterior Concrete Wall Finishing
Exterior concrete wall finishes vary in type and expense. You can install stone veneer, which comes in an array including man-made stone,...