How to Build Mirrored Cabinet Doors

Save

A mirrored door requires only a few basic materials to create and can be built to fit any size of cabinet. Mirrored cabinet doors can provide full-body reflection or be simply for decoration. They can be installed directly to the old cabinet doors or built on new wood to make completely new doors. This is determined only by how much work you would like to do and how receptive the old doors would be to installation of a flat mirror on the main surface.

Things You'll Need

  • Drill
  • Drill bits
  • Plywood sheet, 1/2-inch by 24-inch by 24-inch
  • Tape measure
  • Pencil
  • Saw
  • 4 boards, 1/2-inch by 3-inch by 21-inch
  • Mirror, 3/32-inch by 20-inch by 20-inch
  • Wood screws, 3/4-inch
  • Unscrew the hinge from the door to remove the old cabinet door. Save the screws and set aside.

  • Set the old door over the plywood sheet and trace the outline or transfer the measurements with a tape measure to the new board. Cut out a new board with the same dimensions as the old board, which will be 1/2-inch by 24-inch by 24-inch.

  • Position four 1/2-inch by 3-inch by 21-inch boards with largest sides down in the shape of a square frame, which should be the same size as the plywood door board. Set a mirror which is four inches smaller in length and width on top of the square frame with the mirrored surface facing down. Arrange this 3/32-inch by 20-inch by 20-inch mirror evenly on top of the square frame so there is an equal amount of space all around.

  • Position the plywood board evenly on top of the mirror and frame. Drill holes every 6 inches through the plywood board and into the frame, being very careful not to damage the mirror or go through the frame boards. Set 3/4-inch wood screws in each hole and tighten completely to secure the mirror in place.

  • Position the new door against the cabinet opening and line it up with the hinges. Mark the locations of each of the hinge screw holes on the back of the new door board. Drill a hole into each marking, being careful not to go all the way through the frame. Set 3/4-inch screws in each hole in the hinge and line them up with the holes in the door. Tighten the screws to attach the doors to the hinges.

Tips & Warnings

  • Stain or paint the door to match the rest of the cabinet.

Related Searches

  • Photo Credit BananaStock/BananaStock/Getty Images
Promoted By Zergnet

Comments

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!