How to Replace Controls on Jenn-Air Ovens

Jenn-Air ovens have an electronic oven control, which is located in the control housing of the appliance. The control housing is located above the oven door on both ranges and wall ovens. If the electronic oven control fails, the fault codes "F0," "F1," "F5," "F6" or "F7" are often shown on the display. When these error codes are displayed, you must remove the existing electronic oven control and install a new one.

Things You'll Need

• Screwdriver

Instructions

1. Turn off the power to your oven in your home's service panel.

2. Open the oven door all the way, and remove the four screws located below the control housing.

3. Move the control housing up, and pull it away from the oven to remove it.

4. Remove the screws securing the electronic oven control to the control housing, and remove it from the control housing. Do not disconnect the wires.

5. Transfer the overlay from the front of the existing electronic oven control to the new electronic oven control, if necessary.

6. Install the new electronic oven control using the screws that were used to secure the existing control.

7. Transfer the wires from the rear of the existing control to the new control, ensuring that each connector locks into place.

8. Reinstall the control housing, close the oven door, and restore power to the oven.

References

• Jenn-Air: Electronic Wall Oven Service Manual
• Appliance Parts Pros: Jenn-Air Fault Codes
• Repair Clinic: Oven Control Board