How to Keep Slush From Sticking in a Snowblower

Lubricate a snowblower before blowing slushy snow.

Whether your snowblower is single- or dual-stage, heavy, slushy snow can clog in the auger and the chute. A few quick tricks can prevent the slush from sticking in the snowblower. One of the more effective solutions is a lubricating product offered by snowblower manufacturers that makes the snowblower's auger and chute non-stick. The lubrication coupled with other tricks allows the snowblower to push through the slush.

Things You'll Need

• Cloth
• Clean-out tool or stick
• Petroleum-based snow blower non-stick spray

Instructions

1. Clear any snow or slush out of the snowblower and dry the chute and auger thoroughly with a cloth. Do not place your hands into the chute to clear it, but instead let the auger and impeller run to clear out the snow. If the machine is clogged, clear it out with a clean-out tool, sometimes provided when you purchase the snowblower, or use a stick to dislodge the snow.

2. Spray the auger and chute evenly with a petroleum-based snow blower non-stick spray.

3. Turn the snowblower on and let it idle for a few minutes to allow the engine to warm up. A cold engine doesn't allow the snowblower to operate at full power.

4. Move quickly. The slower you go, the more time the slush has to stick in the snowblower. But increasing your speed forces the slush through the chute at a greater rate.

Tips & Warnings

• Always clean and lubricate the snowblower with the power turned off.

References

• ManageMyLife.com: Getting the Most from Your Dual-Stage Snow Blower