How to Cover an Exposed Basement Ceiling

Exposed ceiling beams in a basement have an unfinished look. There are two main options for covering an exposed basement ceiling -- drywall or a dropped ceiling. A dropped ceiling may make the space feel shorter than it is, so drywall is typically the best option. You will need a friend to help with this project, drywall panels are heavy and it is nearly impossible to do this job alone. Does this Spark an idea?

Things You'll Need

  • Deadman brace
  • Drywall panels
  • Drywall screws
  • Cordless screwdriver
  • Utility knife
  • Drywall tape
  • Joint compound
  • Putty knife
  • Sandpaper
  • Primer
  • Paint
  • Paintbrush
  • Paint roller
Show More

Instructions

    • 1

      Make a deadman brace. Cut a length of 2-by-4 wood that is just 3/4 of an inch shorter than your ceiling. Attach a smaller 2-by-4 to the end of this board, horizontally, to create a "T" shape.

    • 2

      Attach the drywall panels, having a friend help lift each panel. Slide the deadman brace underneath the end of each piece to hold it in place as you secure it to the ceiling. Use a cordless screwdriver and drive in drywall screws through the panel and into the ceiling joist at a rate of one screw for every 12 inches. Secure each panel in this manner. Cut panels as needed using a utility knife.

    • 3

      Tape your seams. Cover every seam with drywall tape. If you use self-adhesive tape, you do not need to place mud underneath the tape. Press the tape down firmly.

    • 4

      Put joint compound over the tape. Use a putty knife and spread a thin layer of joint compound over the tape and over the dimples where you placed your screws. Extend the compound out from the tape by a 1/2 inch on each side. Scrape off the excess as you work. Let this set until it is dry.

    • 5

      Sand down the compound. Use a fine-grit sandpaper. Smooth out the compound until it is flush with the rest of the panel.

    • 6

      Prime and paint the ceiling. Edge with a paintbrush and use a roller for the rest of the ceiling. Let the primer dry for four to six hours. Roll on at least one coat of ceiling paint and let that dry.

Related Searches:

References

Comments

Related Ads

Featured