How to Build a Model Roller Coaster for a School Project

How to Build a Model Roller Coaster for a School Project
••• ekkawit998/iStock/GettyImages

A roller coaster has no engine and works only from the force of gravity from the first hill it is pulled up. In the process, a roller coaster transfers potential energy to kinetic, or real, movement, all from the descent of a hill. Build a model roller coaster for a school project to learn more about the physics behind this amusement-park favorite. Use foam pipe insulation from a hardware store to construct the track and test it with marbles.

1. Cut Out the Track Pieces

Cut both pieces of 6-foot, 1 1/2-inch-diameter foam pipe insulation in half lengthwise so they form a "U" shape. Each pipe comes partially cut. Cut the partially cut side all the way through, then cut the opposite side to create two U-channel pieces per pipe. You should have four U-channel pieces in total with this step.

2. Assemble the Track With Tape

Tape two pieces of foam track together with masking tape. Be sure the tape is smooth inside the foam tube and the channel is on the inside. Curl the track to form a loop, approximately 12 to 20 inches in diameter. Use a ruler to measure its width. Tape the loop you formed together where the two tracks meet.

Tape a third section of track so it connects to one side of the loop. Secure a fourth section of track so it connects to the other side of the loop with the tape. Be sure the tape is smooth inside.

3. Raise the Roller Coaster Track

Raise one end of track up to a bookshelf or table and tape it down with the masking tape. The loop should sit on the floor. Tape it down to the floor.

Measure the diameter of the loop and the height of the track where it meets the bookshelf or table. Measure the total distance of track from the bookshelf to the loop.

4. Test the Roller Coaster

Perform a simple experiment in the transfer of potential to kinetic energy by releasing a marble from the top of the roller coaster and watching it travel down and around the loop. You may need to adjust the height of the initial drop so the marble can make the loop.

Things You'll Need

  • 2 6-foot, 1 1/2-inch-diameter pieces of foam pipe insulation
  • Utility knife
  • Masking tape
  • Tape measure
  • Bookshelf or table
  • Glass marbles

Tips

  • Once the marble can make the loop, add twists and turns or another loop after the first loop. Use more foam insulation as needed.

    Change the diameter of the loop to observe if the marble can still make the loop.

Warnings

  • Young children need adult supervision for this project.

Related Articles

Science Projects With Slinkies
How to Make a Model of the Roman Aqueducts
Egg Parachute Design Instructions
How to Make a 3D Model of the Muscular System for a...
How to Make a Conveyor Belt for a School Project
How to Make an Electric Fan
How to Make a Pulley for Children
How to Build a Space Station Science Project
How to Calculate the Area of a Pipe
How to Make a Model of an Ear for Children
How to Build a Model of a Mini-Basketball Court
Science Projects on Amusement Park Rides
How to Calculate Tire Turns Per Mile
How to Build a Mini Electric Car for a Science Project
How to Build a Rube Goldberg Device to Raise a Flag
How to Build a Dam for a School Project
How to Build a Frog Trap
How to Make Roller Coasters for a Science Fair Project
How to Make a Fake Inhaler for a School Project
How to Calculate Conveyor Belt Speed

Dont Go!

We Have More Great Sciencing Articles!