Troubleshooting an American Flyer if Short in Track
American Flyer is not as well known today as its former rival, Lionel, but at its height during the mid-20th century it was one of the big players in the American model train market. Die-hard enthusiasts still collect and operate American Flyer trains, keeping the brand alive. One of the more common problems encountered when operating an American Flyer train is a short circuit somewhere in the track layout. Fortunately, a few tasks are all that is required to diagnose and fix the problem.
Other People Are Reading
Things You'll Need
- 22-gauge wire
- American Flyer transformer
- Thin screwdriver blade or similar thin, sturdy object
Instructions
-
-
1
Inspect the track for metal objects that may be in contact with both rails of the track. If you find such objects, remove them.
-
2
Connect one end of a 22-gauge wire to the base post screw of an American Flyer transformer.
-
-
3
Connect the other end of the wire to the base post clip of the terminal track, or place it in direct contact with the section's outside rail.
-
4
Connect one end of a second 22-gauge wire to the 7- to 15-volt post of the transformer.
-
5
Turn on the transformer near the midway point of its power setting.
-
6
Swipe the free end of the second wire against the section's inside rail.
-
7
Look for a spark, which indicates a short in that section of the layout.
-
8
Repeat the procedure, if necessary, for other sections of the layout where your train fails to operate properly.
-
9
Inspect the sections you've determined to have shorts. American Flyer tracks have a small piece of insulation keeping the ties or sleepers from making contact with the rails. This insulation can shift out of position, allowing contact to take place and causing a short.
-
10
Prod the out-of-position insulation gently back into place using a thin screwdriver blade or similar thin, sturdy object.
-
1
Tips & Warnings
Keep all scenery containing metal a safe distance from the track so that if the scenery is knocked over it won't fall across the track, causing a short.
Do not turn the transformer to maximum power when testing for shorts.
Make only light glancing contact between a free wire and a rail.
