How to Drill With a Ditch Witch
The Ditch Witch SK350 is a mini skid steer unit designed for a variety of construction tasks, including lifting and drilling. Drilling is accomplished through the use of a special drilling attachment, which can then be controlled through the use of the SK350's lift arm. If you wish to drill with the SK350, you can do so easily by making use of the device's control panel.
Other People Are Reading
Instructions
-
-
1
Insert your key into the Ditch Witch's ignition switch, located on the right side of the vehicle's control board. Turn the key to start the vehicle. If the engine is cold, pull on the choke knob, located above the throttle, to help start the SK350.
-
2
Engage the drill attachment by lifting the attachment drive control, located below the lift arm control, and pressing down on the attachment drive foot control pedal with your foot.
-
-
3
Push forward on the lift arm control lever to move the drill attachment into the ground and begin drilling. When you are finished, pull back on the lift arm control level to raise the drill away from the ground, and power down the Ditch Witch.
-
1
