The newly available brush-on resurfacers restore a like-new appearance to walks, drives and patios. Often they're the only way to disguise a repaired concrete surface, such as porch steps.
Things You'll Need
- Muriatic Acid
- Concrete Resurfacer
- Foam Backer Rods
- Paddle Mixer
- Steel Towel
- Hose And Nozzle
- Plaster Brush
- Stiff Broom Or Brush
- Wide Squeegee
- Mixing Container
- 1/2-inch (12-mm) Drill
- Pressure Washer
- Shop Vacuum
- Wood Float
- Plastic pail and brush, or spray bottle
Make any required repairs to large cracks, broken corners, steps or similar concrete damage (see How to Fix Cracked or Damaged Concrete).
Cut back any grass or plants along a walk or driveway you're resurfacing, and press foam backer rods into expansion joints so you won't end up filling them with resurfacer.
Pretreat stains, which can interfere with bonding, using muriatic acid. Dilute the acid in a plastic pail or spray bottle by adding 1 part of 20 percent acid to 4 parts water (see Warning). Carefully apply the acid solution to the affected areas using a brush or spray bottle. Allow it to work for a few minutes, then hose it off.
Wash surfaces from the center outward. Use a hose and nozzle or (better) a pressure washer, which you can rent.
Use a shop vacuum to clear loose material out of cracks. Don't blow it out or you'll contaminate the surfaces you just cleaned.
After you've gathered your tools, soak the surface with water and brush off any standing water.
Mix the resurfacer with water as directed, using a 1/2-inch (12-mm) drill with a paddle mixer.
Level depressions and fill small cracks. Allow these repairs to dry before coating the entire surface.
On horizontal surfaces, apply resurfacer with a trowel on small areas, such as stair treads, or with a wide squeegee on large areas, such as walks. For vertical surfaces, such as stair risers, mix the material with slightly more water and apply it with a plaster brush. Have containers of water available so you can quickly rinse off trowels and brooms between uses. Work in manageable sections. Proper application techniques take some practice, and the material sets up quickly (in about 20 minutes).
Finish and texture the material as you apply it. For a smooth surface, use a steel trowel in a circular pattern. For a slightly rougher texture, use a wood float, which you can make by putting a handle on a block of wood that has slightly rounded corners. For the very rough finish typical of sidewalks, draw a stiff broom or brush across the surface.
Tips & Warnings
- Use liquid-concrete colorant as directed to color the resurfacer.
- Muriatic acid is highly corrosive. Read the warning label carefully. Wear goggles and rubber gloves, and never add the water to the acid. It will spatter like water added to hot fat.
- Wear work gloves, knee pads and other protective clothing as needed.
How to Fix Cracked or Damaged Concrete
Timely concrete repairs may prevent water intrusion and extensive damage, enhance the appearance of surfaces, and correct potential safety hazards. Concrete patches...
How to Replace Stair Risers
Stair risers can take a beating over time. When wear and tear starts to show, you may need to replace them. When...
How to Stain Concrete Steps
Concrete is used for a wide range of surfaces, such as walkways, patios, driveways, pool decks, planters, walls, floors and steps. Newer...
How to Make Old Concrete Look Good
Old concrete is dull and gray and not necessarily an attractive finish to a floor. While putting carpeting or hardwood floors over...
How to Make an Old Concrete Driveway Look Good
Old and worn concrete can become dull, gray and unattractive. Wear and tear from cars causes cracks, then water seeps into those...
How to Resurface a Cracked Concrete Driveway
Concrete driveways are popular because of their durability and low cost. But concrete can crack and become pitted after several years exposed...
How to Overlay Concrete Driveways
A concrete driveway should last for many years. Unfortunately, harsh weather and other factors can damage the surface. Rather than replace the...
How to Use Pavers Over Concrete Steps
Existing concrete steps can be relatively dull in appearance but do offer stability and durability to a landscape. An option to increase...
New Ideas to Fix a Cracked Concrete Patio
When cracks are substantial enough or the concrete is old enough, it is often best to go the extra step to rejuvenate...
Ways to Improve an Old Concrete Patio
A patio is an extension of your home into the outdoors, serving as an outdoor living space. It's the ideal location to...